The work continues….
The OTA (Over The Air) antenna has been installed. We installed a Winegard Sensar IV We spent a lot of time tracing the wiring and figuring out how the existing wires were run. We have them all done except one coax cable which we cannot find where it terminates. We will keep working on that.
We drilled a hole in the roof to bring the crank handle down through the roof.
The crank handle raises and lowers the antenna and turns the antenna when it is raised so you can get the best picture on the TV.
We brought the coax cable down into the closet where the Bedroom TV will go.
Sealed and screwed down the antenna and cable.
Connected it to the plate supplied with the antenna.
The Plate lets you connect two TVs and brings 12VDC up to the amplifier in the antenna. We tapped off the light in the closet for the 12VDC.
We connected the second TV connection to the existing coax that goes over to the entertainment center in the living room. So now we have OTA Digital cannels in the bedroom and the Living room.
When I say We above I am referring to Myself and my good friend Ralph, who has helped me all through these upgrades. For that matter has helped me renovate my house and just about anything. Thanks Ralph, I could not do this without you.
Number of visitors:
No comments:
Post a Comment